Constant and variable amplitude fatigue of members, welds and bolts to IS 800:2026 Section 19: Table 26 detail categories, Table 25 safety factors, thickness correction, cumulative damage, exemption check and fatigue life.
| Use it for | Crane gantry girders, crane runway details, members, welds and bolts under repeated loading |
|---|---|
| Checks (IS 800:2026 Section 19) | 19.1 scope · 19.2.1.1 thickness correction μr · 19.2.1.2 when fatigue assessment is needed and the exemption conditions with ffeq · 19.2.2.1 Table 24 multiplying factors (entered) · 19.2.3 partial safety factors, γff = 1.0 and Table 25 γmft · 19.3 / Table 26 (A) to (D) detail categories · 19.4 S-N curves (slope 3 up to 5 × 10⁶, slope 5 to 10⁸) · 19.5.1 design strength · 19.5.2.1 / 19.5.2.2 stress limits · 19.5.2.3 / 19.5.2.4 constant and variable amplitude (cumulative damage) assessment |
| You enter | Detail ID; Table 26 detail category for normal stress and for shear; consequence of failure and inspection (γmft); thickness correction for transverse welds joining plates thicker than 25 mm; Table 24 factor; steel grade and thickness; maximum service normal and shear stress; design life and working days per year; up to six load blocks of stress range and cycles per day |
| You get | Total cycles NSC, γmft, μr, design fatigue strength ffd, equivalent range ffeq, exemption check, cumulative damage Df and Dτ, stress-limit checks, fatigue life in years, governing utilisation ratio, ADEQUATE / NOT ADEQUATE, and a live S-N chart with your load blocks plotted |
| Not covered | Stress ranges are entered, not calculated (derive them from your analysis at the detail); rain-flow counting of irregular histories; interaction of normal and shear stress at the same point; corrosion, low-cycle and thermal fatigue; temperatures above 150 °C |
Good with Pack C: SH02 Gantry Girder Design does not check fatigue; FT01 does. For a gantry girder, one crane pass is one cycle and Δf = (Mmax − Mmin)/Z at the detail. See Pack C.
About the workbook
- Software: Microsoft Excel 2016 or later on Windows or Mac, including Microsoft 365. No macros, add-ins or internet connection needed.
- Tabs: Guide, Input (inputs, live results, live S-N chart, detail-category help), Summary (one-page report), Detailed (clause-by-clause calculation), Project (report title block).
- Reports: A4, print or save as PDF. Every page carries your company, project, client, document no., revision, date, designed / checked / approved by and issue status. Your logo can be added to the report header.
- Protection: yellow input cells only; everything else is calculated and locked.
- Same format as Packs A, B and C, with the same Project tab and title block.
- Support: Ilustraca Academy, ilustraca.tech@gmail.com
Engineer’s responsibility: this workbook is a design aid. Results must be reviewed by a qualified structural engineer, who remains responsible for the design.
